Search This Blog

Thursday, November 04, 2010

Config Dell Remote Access (DRAC) via Windows CMD

I recently discovered that you can configure the DRAC from within windows. If you have installed the DELL server administrator.

You can configure from the command line, using the racadm exe.

racadm setniccfg –s <drac ip> <drac subnet mask> <gateway>

racadm setniccfg -s 192.168.x.x 192.168.x.x

I had to setup some servers that already had windows installed. Normally I configure the DRAC via the boot menu. As you can see you can do it without rebooting.

Not sure what other items you can configure but hopefully this will point some people in the right direction.

note: the racadm is in the following location (although I believe it is added to the system path so should run from anywhere).

C:\Program Files\Dell\SysMgt\RAC<versionnumber)\


No comments:

Post a Comment